|
Engine Control Modules  ComAp Electronic Potentiometers (2 wire) - CA EP250  |  | Features:
- Two wire variable resistance output
- Adjustable initial value, ramp rate and end stop.
- Typically used with speed governors for combustion engines or voltage regulators for alternators.
- 106mm x 90mm x 73mm
|
| ComAp Intelimains - CA IG-MAINS |  |
General information
- For multiple up to 31 gen-sets operating in parallel to mains
- Import/export power control of the gen-set group
- Reverse synchronization of the loaded gen-set group to mains
|
| ComAp MAINS PROTECTION UNIT - CA IG NPU-FU |  | General information
- 3-phase mains protection
- Frequency, voltage and voltage asymmetry protection
- Enables to switch on/off available protections
- Adjustable limits and time delays for each protection
- Rated voltages:100, 230, 400, 480 VAC
|
| ComAp MAINS TRANSFORMER UNIT - CA IG MTU |  | General information
- Set of 3 mains voltage transformers 400V/230V
- Galvanic separation of the mains and generator voltage
- For three wire system, system with separated Neutral or when galvanic separation between generator or mains voltage and controller is required
|
| ComAp Power cont Module - CA IG-PCLSM |  | General information
- For isolated parallel or parallel to mains operation
- Analog isochronous load sharing line
- Automatic forward and reverse synchronizing
- Speed/voltage control
- Load control including ramping
- Power factor, import/export control
- Additional 4 binary inputs and outputs
|
| ComAp Power Control Module - CA IG-PCM |  | General information
- For parallel to mains operation
- Automatic forward and reverse synchronizing
- Speed/voltage control
- Load control including ramping
- Power factor, import/export control
- Additional 4 binary inputs and outputs
|
| ComAp AVR control interface - CA IG-AVRI |  | General information
- Interface between IG-PCM/PCLSM or InteliSys and generator AVR
|
| ComAp Comm & Power Management - CA IG-COM |  | Enables communication among InteliGen/InteliMains controllers via CAN bus
Enables Power management feature of InteliGen controllers
Attached at the back of InteliGen/InteliMains controller |
| ComAp Potentiometers (3 Wire) - CA EP300 |  | Features:
- Three wire voltage divider output.
- Adjustable lower/upper limits, start point and ramp rate.
- LED display of current setting and parameters.
- Typically used with speed governors for combustion engines or voltage regulators for alternators.
- 160mm x 90mm x 73mm
|
|